This is description of this part:
Complete illumination for Lomo MICMED-2 microscope: rear-mounted halogen illuminator attached to the microscope base and internal components responsible for power supply and light control.
The set consists of the following elements:
- halogen illuminator
- halogen bulb
- potentiometer
- transformer
Markings:
- Illuminator: TU-9443-076-07502348-96 WAR-2 (BAP-2)
- Potentiometer: PPB-25G 0310 2.2 Ohm +/- 10%
Note - this is an illuminator for the Lomo MICMED-2 (two) microscope. In the 1990s a microscope model was sold under the name "Micmed" (without "2"), which is commonly known as "Lomo Biolam". This illuminator DOES NOT FIT this "Biolam-Micmed".
The marking "WAR-2" (in Cyrillic BAP-2) on the illuminator indicates "version 2".
This repair element may solve the following issues:
- Lomo MICMED-2 microscope is missing the illuminator
- power supply in Lomo MICMED-2 microscope is burned out
- illumination in Lomo MICMED-2 microscope does not work
- halogen bulb holder in Lomo MICMED-2 is broken
- how to repair power supply in Lomo MICMED-2?
- light intensity control in Lomo MICMED-2 does not work
Various names are commonly used for this microscope service element:
- power supply
- transformer unit
- lamp
- bulb holder
- lamp socket
- lamp housing
- halogen bulb
- illumination
- illuminator
- electrical system
- electronics
- electronic board
- potentiometer
- brightness control
- dimmer
What is this part needed for?
- if you have a Lomo Micmed-2 microscope without an illuminator
- if the power supply (electrical component) burns out due to a fault, storm, power surge, liquid spillage, short circuit, or, for example, an error in modifying the lighting.
- if the bulb housing is damaged
- if the ON-OFF switch is damaged
- if the potentiometer is damaged
