Home page of the microscope service parts, repair and spare parts online catalog - Sermik-Oplatek Mikroskopservice Dresden f.n.n.Z

Description of this part for the microscope.

controls the shutter. It is not a complete shutter. The module contains:
- a milled aluminium bracket that fits inside the microscope housing
- the Kuhnke D 23 LOL -F 24VDC 100%ED rotary solenoid
- two HOA2001-1 optical sensors
- the wiring and the connector to the Zeiss 451331-9320 board

I was not able to confirm it, but it is possible that this part also fits the inverted Zeiss Axiovert 135M microscope. Before you decide to use the electronic module shown here in the Axiovert 135M model, please check this on forums or groups devoted to Zeiss microscopes.

In the last photos the arrow shows where this part sits in the Zeiss Axiovert 100M microscope, so that you can identify it without any doubt.

Description of this part for the microscope.

sensors and drives in the motorized inverted Zeiss Axiovert 100M microscope are connected.

Markings on the board:
- 451331-9320
- 3320 B
- DL SP1 SP2 SHUT
- SCA
- 3320 L
- Carl Zeiss Jena

ATTENTION: This is a board for a microscope branded by Zeiss (Oberkochen, West Germany). The board, however, carries the "Carl Zeiss Jena" logo. This is not a mistake - this board was made in week 31 of 1997, already after the German reunification, when the Jena plant was producing for the entire Carl Zeiss group.

IMPORTANT: in the photo you can see that in every pin block onto which a connector is plugged, one pin is missing. This is not damage, this is not a broken-off pin - this is the original factory condition. It is supposed to look like this.

I was not able to confirm it, but it is possible that this part also fits the inverted Zeiss Axiovert 135M microscope. Before you decide to use the electronic board shown here in the Axiovert 135M model, please check this on forums or groups devoted to Zeiss microscopes.

In the last photos the arrow shows where this part sits in the Zeiss Axiovert 100M microscope, so that you can identify it without any doubt.

Description of this part for the microscope.

board carrying the two momentary pushbuttons:
- 452112-9036
- S8/10
- 452112-3036 L
- S9/11

Marking on the cable connecting the microswitches: 451331-8094

The connector plugs into the SCA socket on the central distribution board 451331-9320 (https://www.microscopeparts.eu/part/99909).

I was not able to confirm it, but it is possible that these parts also fit the inverted Zeiss Axiovert 135M microscope. Before you decide to use them in the Axiovert 135M model, please check this on forums or groups devoted to Zeiss microscopes.