More about part: Zeiss Axiolab microscope stage carrier and condenser holder assembly with rack and pinion incl condenser height adjustment knob (ID: 99936)
Main Photo
Description
Zeiss Axiolab microscope stage carrier and condenser holder assembly with rack and pinion incl condenser height adjustment knobBlock holding the ring dovetail for mounting the microscope stage together with the condenser holder for Carl Zeiss Axiolab microscopes.
This assembly was removed from a Zeiss Axiolab re microscope, P/N 45 09 05 (also written 450905). It also fits the following variants:
- Zeiss Axiolab drb KT, which carries the same number 45 09 05 (450905)
- Zeiss Axiolab E re, 45 09 07 (450907)
- Zeiss Axiolab A, 45 09 09 (450909)
- Zeiss Axiolab Pol, 45 09 10 (450910)
In the Zeiss Axiolab microscope focusing is done by raising and lowering the whole stage and condenser assembly.
The module consists of the following parts:
- main load-bearing casting with the ring dovetail for mounting the microscope stage, dovetail diameter 98 mm (casting 6527). The main vertical movement rack is screwed to this casting ([[ LINK ]])
- Allen screw clamping the stage in the ring dovetail
- condenser carrier (casting 6528)
- control knob for condenser movement
- shaft with the pinion that drives the condenser rack
- condenser rack
- height stop screw limiting how far the condenser can be raised or lowered
- centrable condenser mount with a ring dovetail diameter of 53.6 - 53.8 mm. This mount is a separate casting (number 6531) seated in the frame of the condenser carrier
- clamping screw for the condenser
- two centring screws for the condenser
In the last photo an arrow shows which element is meant and where it sits in the microscope so that the part can be identified without any doubt.
Replacing this complete block can help with problems such as:
- one of the delicate castings has cracked or chipped
- the small clamping screw for the stage has been lost
- the plastic condenser height adjustment knob is damaged, for example broken
- the teeth on the pinion or on the condenser rack are bent or broken off
- casting 6531 is missing and the condenser cannot be mounted without it
- the condenser centring screws are missing or damaged, for example bent
Manufacturer
Zeiss - (Carl Zeiss West Germany) ➔ All parts
It comes from
This part was removed from the following microscope:
Why do you need this?
This microscope part is typically used for the following purposes:
- if this part or one of its components has been damaged in your microscope, for example the knob, the rack, the centring screws, or if one of the delicate castings has cracked
- some of the possible kinds of damage are listed in the description
Compatibility
This microscope part is compatible with the following microscope models, among others:




