More about part: Zeiss IM 35 / ICM 405 microscope pinion gear from rack and pinion focus drive (ID: 99959)
Main Photo
Description
Zeiss IM 35 / ICM 405 microscope pinion gear from rack and pinion focus driveA single gear wheel - a service part from the gear train of the focus drive in the Carl Zeiss ICM 405 / IM 35 inverted microscopes.
In the Zeiss IM 35 and Zeiss ICM 405 inverted microscopes, focusing is done by raising and lowering the nosepiece with the objectives. The rotary movement of the focus knobs is converted into the vertical travel of the nosepiece by a gear train with two steel gear wheels.
What I offer here is exactly one of those gear wheels - a rack and pinion gear.
- Material
- steel
- Construction
- gear wheel with a pinion on the shaft
- Diameter of the gear wheel
- 35 mm
- Diameter of the pinion
- 7 mm
- Centre
- there is a bore in the middle which takes the shaft
The last photo in the gallery shows the body of the Zeiss IM 35 microscope with the side covers removed. An arrow points to where this gear train sits inside the microscope. The other photos show the gear train already taken out, with an arrow pointing to the gear wheel in question. This allows the part described here to be identified beyond any doubt.
Manufacturer
Zeiss - (Carl Zeiss West Germany) ➔ All parts
It comes from
This part was removed from the following microscope:
Why do you need this?
This microscope part is typically used for the following purposes:
- as a service part for repairing the gear train in the Carl Zeiss IM 35 / ICM 405 inverted microscope
- when a single gear wheel has to be replaced, for example with broken teeth
Compatibility
This microscope part is compatible with the following microscope models, among others:



